Cosplay Mask, Hat and Wig Stand V2

This is a Mask, Hat and Wig Stand. The design emphasis was minimalism and speed of printing.

In this remix I have separated the parts so that the thing can be printed on a 220 x 220 build plate at 100% or on a 200 x 200 build plate at 95%.

Conversely the V2 protoype was a little large for my Batman Cowl so therefore I probably should have reduced to 95%.

Parts are a reasonably tight interferance fit but can be glued for greater security.
Printing Instructions:
1.The things were printed fast using a 0.8mm nozzle, 0.6mm layer height and @40mms. 1 perimeter and 7% infill.
2.Further speed reductions may be achieved with only printing bottom layers and rely on the infill for rigidity. Average print time at these settings was approx. 35 minutes.

Schreibe einen Kommentar

Deine E-Mail-Adresse wird nicht veröffentlicht. Erforderliche Felder sind mit * markiert.

Diese Website verwendet Akismet, um Spam zu reduzieren. Erfahre mehr darüber, wie deine Kommentardaten verarbeitet werden.